Piping Offset Calculator

Un peu du mal à comprendre comment ça marche

Zeer goed

I’ve been in the trade for 13 years and have done these calculations by hand. Still do. This app was fairly accurate if you stayed below 10” for your rise and run. But the travel length the app gives oddly seems to be cut in half of what it actually is. Anything I tried with the rise or run over 10” was just turned out to be the wrong measurement. Don’t waste your money like I did.

I update to the last version in Nov-14, and after that, the app crash every time. I have IOS 6.1 in my iPod touch 4, which should be compatible with this app.

Can't get it to operate on iOS 8.2 Tried to email but could not get through to them tried repeatedly can't get through their spam filter

I mistakenly bought an app made by a competitor first, it seamed ok at first then an update made it very confusing. So in frustration I purchased this app and wow, it's so simple a stupid pipe fitter like me can use it. Don't look anywhere else, you have come to the right place first. I have now purchased two other apps from this builder and like them just as well. Thanks for making your apps stupid simple!!

Great helps out a lot

Awesome app

I've been using this app for awhile. This app solves all offset configurations. There are no other apps that do what this app does. Enter in the dimensions or angles is super easy. Output works every time. Dimensions are perfect. No fit up problems. Measure twice and cut once is all I have to remember!!!

It has a lot more offset&roll options. Allows choice of angle, adding weld gap, 4 options for fitting radius including user input choice. Tap the side/angle on the drawing to enter your options can't be more user friendly than that :-)