airHeaterByBLE

My 5 year old could do better

The app won’t connect if you’re using a newer phone. I have managed to get it to work with an older iPad but really to helpful having to carry an extra device just to control the heater. The situation would be more bearable if the app actually offered any real functionality like being able to set timer functions etc. Definitely a lot of room for improvement.

This app is nearly useless, really no better than the remote control Gives very little information. Main screen is so much better. No pump information. Does not show glow plug on/off. Does not allow time settings. Really what is the point. 1 paid well over the odds for my heater to be controlled by the app, as my heater is installed outside. It does give very basic control. But come on, was this programme written by high school kids.

Come on tech guys this is a little poor The Main screen is better than the app. Not animated ? No fuel level? No settings ? Some History data maybe amps? Pump can’t be controlled properly an update is needed

App doesn't show the same as the heater itself. And loses connectivity often.

It would be great if we were able to change from Celsius to Fahrenheit like we can on the diesel heater controller. Other than that the app seems to work just fine.

Basically you can only turn the heater On and Off, nor can you turn the speaker off. The controller itself is far more complicated than the other brands, it is cheap, it kinda works, but it’s a pain. Once it breaks I won’t be buying this brand again

Don’t bother connecting. This app will not reconnect. Try to reconnect error message “warning connection failed” then go to try and reconnect with bluetooth button and amazing, I have to disconnect from the heater. Probably only supporting android because Iphone protects user data.

It really is a handy little app for this heater. But not being able to change from Celsius to Fahrenheit is tough. Lol. Also not a whole lot going on in the app. I figure I’d be able to do a lot more. Maybe have it turn on at a certain time?

The app only seems to work when you first install it on an iPhone. After that when you try to connect it fails. If you select the ”Sacn” (probably supposed to be “Scan”) it says you have to disconnect first. If you disconnect it tries to connect again and fails again. It’s an endless loop of failure.