This app easily helps you measure filament left on your spool of filament. Using preset profiles only takes a minute and can give you a good estimate of filament left.
When I first saw this app I thought it would be very useful to me in the event that I’m praying apart and I’m sure if I’m gonna have enough filament to finish the print. However I found that once I got it set up not only did it not store any additional presets I try to add, but even when I use one of the included presets it only seem to tell me that I needed to buy more.Obviously I know when I need to buy more filament and it telling me I need to do so I found to not be helpful at all. I was hoping it would give me some meaningful data in terms of amount of filament left on the school in grams or meters so I could know if I would have enough to make my print complete. Hopefully it’s just growing pains and there’s something wrong with the apps coding that is being fixed but until then I don’t see this app being helpful.
Must need app for 3d printing!
This app is super useful when it comes to 3d printing. I would always run into problems with calculating how much filament is left on my spool but this app has helped out a lot. I especially adore the scan feature which simplifies the process even more.
Very helpful app
I love the idea of this app and I think it was pulled off very nicely. It is very helpful when it comes to calculating how much filament I have left and I found it is very accurate. It might need a few more tweaks here and there, but it’s still a new app so that’s understandable. I am very happy that I found the app.