BiRemote

The app is working with 3D printers (dual extruders) based on the Marlin Firmware.
Currently compatible printers
- Bibo2 3D with dual extruder
V2.1
- Support uninterrupted upload when leaving app
- Remember Pre-heat steps selected
V2.0
- File Transfer from any location to SD/USB
- Support transfer to subfolders
- Google Drive, SMB share, DropBox, iCloud native support
- Optimizations
V1.1
- Folders and subfolders are now supported on SD/USB
- Graphic improvement for iPAD and M1 -Macs
- Possible to change pre-heat values in step of 10 degree
V1.0 allows you to:
- Connect to your printer over Wifi
- Monitor printer state and print progress
- Allow you to Pre-heat the bed and extruders
- Position bed and extruders for maintenance
- Let you remotely select a file and print from SD or USB
Note that on your machine go into the wifi settings and you should find the IP address. Works in both AP and STA mode.