Dirac Live

Crashes after measurement and when starting the filter export Version 3.10.3

I missed the instruction to plug in the microphone into the NAD M10v2. I downloaded the app and assumed it used the Iphone microphone. I got the message there was too much noise. Therefore I was looking for the Iphone setting to give microphone access to the app. I realised the app didn’t usa a microphone. I used the NAD microphone via the amplifier usb and the Iphone app and it worked very well 😊

Works perfect with my NAD M10 V2

In the beginning it worked good but after a few years I decided to measure again the sound profile for my NAD T778. I have the mike on a special stand and are not even ion the room but it constantly comes back with the message that there is too much background noise…. So sometime during an update of this app they broke the functionality.

Na een automatische update van de app werken de opgeslagen filters niet meer. Hij blijft maar laden en doet er verder niks mee. Heel vervelend weer alles overnieuw😒

App in combination with NAD t778 only gives the error error in samples. Can not be used with my latest iphone.

Really annoying, I set everything up but the app has only been giving errors from the very start. Simply disappointing even for a free app.

Can’t get it connected to Onkyp, kept getting error with mo futher instructions

I have tried many, many, many times to get this to work. It does not work. Either the signal is too low, or the signal is clipping. Never is the signal at a level the app can use. Its pointless.

Using an NAD 3050. App connects to the receiver but when I go to take the measurements, I get a “signal to low” error. The error blames the background noise and/or volume even though the room is dead silent and the gain is pretty healthy. Couldn’t get pass the first step so I couldn’t setup a filter.