After Major Update…
After the major update… 1. the opening no longer automatically stick to the end of walls… this causing extremely inconvenience… 2. the opening which lower than wall height, it’s no longer display on 2D drawing which cause extremely inconvenience… 3. New Added multiple selection is very good, yet the copied paste objects height is reset… this causing the function a bit useless… and the position of the multiple selected item is not able to adjust one shot… which is less convenient… 4. Multiple selection should including selection of rooms, so that height of rooms can be adjusted one shot instead of one by one… or each project is able to preset building heights not only default of 8’10”… More suggestion: 1. Size of room, objects may set by number instead of only dragging… example, set the geometry of 1” after 12 repeats it always ran to less than or more than 1’… measurement run too much after more repeats…