Hot Spring® Spas

You cannot change the light color in the app. Can you please add this to the app? Also would be nice to open up the interfaces so we can easily control with home automation like home assistant or apple homekit. I just got the salt freshwaterIQ system on my 2024 Limelight Pulse. However, I cannot view the information it provides, on the app. Can you also add that spa accessory? Thanks for listening!

App is free, but you can’t use it unless you’ve installed a kit, only purchased and installed through a dealer that will cost, installed, over $800. I was exited to hear that this kit was available, as I just installed a solar system and need to reduce my energy usage between 4-9pm. The “summer timer” is an 8 hour block, take it or leave it (was not intended to use for energy savings purpose, but rather safety to ensure spa doesn’t get too hot when sun is beating down on it.) This app really misses the mark. • No HomeKit compatibility (or any smart home system connectivity whatsoever.) • No ability to time any kind of event (don’t heat between 4-9pm) • no way to start a clean cycle • no way to program the lighting moods, or change lighting color. • no dashboard to monitor things like when it’s time to replace the water, or clean filters. • no calculator, pre-populated with your model’s gallon capacity, to help you properly dose chemicals based on usage activity Hot Springs really needs to reconsider the software developer they chose to partner with to get this done. Why spend $800 if I can’t even automate such a basic thing - like turn off for 5 hours every day at this time?

The app provides the basics such as: Set water temperature Turn on/off jets Turn on/off lights Here's where it falls short: Does not provide notification if the water temperature is dropping (For those of us in cold weather climate this is a major missing element) Though you can turn on the lights, you cannot set the color Notifications can be emailed or seen in the app. No option for texting. The app should present a dashboard of potential issues such low temperature, filters need cleaning, slat system offline….

Nice to be able to run basic things and monitor conditions from the app without having to go to the outside panel. Would love to see a version available on Apple Watch. Also would be great to be able to toggle the light colors on the app as well as run a clean cycle. Thanks!

Spa says ready when you connect to it. It seems to work ok.

So far so good - had a small request for next revision or update - can we add some shortcuts (Apple shortcuts app)? Control of my hot tub in the Apple ecosystem is what I’m really after. Would love to be able to run cleaning cycles automatically and bring the tub in and out of summer savings mode according to a schedule, or dial the temp down during certain times then bring it up to desired value just prior to use. Thanks!