MagicSDR

Come da titolo, finalmente posso utilizzare KiwiSdr da iPhone senza tenere attivo il browser. Non metto cinque stelle per incentivare a dei miglioramenti a livello di interfaccia grafica, dei comandi e settaggi vari, attualmente un po’ macchinosi e non intuitivi. Sarebbe molto gradita la gestione dei server KiwiSdr preferiti.

App molto bella, unica pecca è che non si può settare il livello dello squelch, mi auguro venga implementato

The app works great and allows to listen to your SDR on an iOS device. The developer is extremely supportive. Well done!

I have been running a public KiwiSDR receiver for years and always wanted an IOS client for it. Although very limited (see below) this app is an answer to that. The app will connect to KiwiSDR receivers and open a raw IQ stream. It will then proceed to demodulate the received stream within the app itself (AM,FM,SSB,CW are available). This is drastically different from how a KiwiSDR receiver normally works, the biggest difference being that you will only be able to see about 10KHz of spectrum bandwidth instead of 30MHz. The user interface is very, very basic and at times hard to use. Overall, however, this is the only IOS client I know of that works with my KiwiSDR and therefore I will keep using it. Note: I also tried the app with an RTL-SDR dongle but I was unable to do it successfully due to an error about Soapy that shoes in the logs.

It said that it didn’t need any additions , like hardware. It DOES need hardware to use. I want refund

It seems no wfm demodulator.

App is working ok on rtl_tcp and spyserver network but is pretty much useless since it does not run in background. If you switch between the apps or do anything else on your phone the app disconnects from server. And no, it is not IOS limit since other SDR apps continue to stream in background just fine. So very limited usability.

Bought MagicSDR FOR iOS. Have AirSpyHF Discovery. Have Raspberry Pi 4. Trying to install MagicLink server. Downloaded. Says need a Redhat Platform 5.14 which has been obsolete for more than a year. Tried to install. Looked like it did but when tried to install magiclink.flatpak it couldn’t find it. Spent $9.99 for MagivSDR! What do I do to get this server running. Also where is setting to set up address of the server in the app?

Great idea. Nice graphics but without audio I can only watch the graphics. Had no trouble connecting to rtl_tcp server. Emailed tech support but no response. Doesn’t work as described. Don’t waste your money on this.