NFC LABEL

This app is very close to useless. When using on my phone all the configuration fields are black. I can type in the field but can’t see what I’m typing. Through trial and error I figured out how to edit a template into something I was happy with. There is no tutorial or info on how to create you own design leaving the average joe to use the templates and even then it’s a struggle. I was able to write to 3 of my tags with no issue. My fourth would only show half the written image. I tried multiple times and ultimately had to pry the back off and disconnect the battery for a few minutes. I reassembled and tried writing again and it worked then. Not sure if that was an app problem or tag problem. I’m assuming it’s a combination of the app sending bad data and the tag not being able to deal with that till power cycled.

When writing to a tag, it writes only part of the image.

Works ok but I think the UI is quite difficult to use. How does one select red text? What goes in the configuration fields? Why do the text boxes that you type in go black so that you can’t see what you’re typing?