Revo Scan-3D scanner app

I noticed when you use the app with the scanner, and also use it to convert it to a Mesh, it is very low quality, as compared to the Desktop App , and also there is no way to change the Mesh settings to be able to create a higher quality file. I hope in next update , you add the function of being able to save the file in higher quality Mesh file.

Junk , does not work on iphone 15

The scanner works fine on a laptop, but I bought the portable scanner to use with my phone. I have to connect the scanner to the app via WiFi and it barely works, or more often simply doesn’t. The iPad Pro, iPad Air, and iPhone 15 add have USB C, it’s high time that these guys modify the app to use USB support so we don’t have to try to rely on the extremely spotty WiFi connection to the app.

This app is terrible. I have issues with connecting to the scanner, then performing the scans. I connect power to the unit and wait about 30 seconds. Then I connect to the scanner’s WIFI. Then I open the RevoPoint app. Fir a very, very long time, up to 7 minutes, the app says, “No scanner detected. Connect a scanner.” Finally if/ when it connects, I get to the section where you set the scan settings. Once i do that and then press the button to start the scan, I get 4 spinning red dots, and one of two things happens: 1. In up to 5 minutes, the 4 round dots go away, and I can scan. 2. The spinning red dots never go away. Then I force close the software and start all over again. Sometimes I’m not able to get it to scan no matter what I do. This does not happen on the computer app. I’m running IOS 16 on an iPhone 13. I do not remember this happened when I first got the device. 2 things changed since then, a scanner firmware update, and updating to IOS 16. Once I do get a scan going, the phone app does have significantly more trouble keeping tracking of the object than on the computer. I tested this by scanning the same object using both methods. Also, not related to this app, but it seems this device in general, works much better when the scanner is stationary, but the scanned object is placed on a rotating platform. Unfortunately this isn’t always feasible unless you are scanning a small object.

Literally everything for the Pop2 is non-functional. I cannot get the Mac software to work at all, so I decided to try the iPhone software… dude, huge mistake. I’m glad I haven’t thrown away the box yet, because this paperweight is going back.

When will this app be available for the iPad with USB C compatibility? I believe the next-generation of iPhones will also have USB C connections so why wait? I really want to use this app on my iPad Pro with USB C support. Thanks!

Unbelievable for me, the first time I could scan the object within such limited slot and create amazing modeling, very nice experience^~^

If you are looking to scan tiny objects on a turntable, this might work for you. I bought the revo point pop 2 device and paired with this app, it is a frustrating experience. After about 10 attempts with different settings, I have not produced any usable scans. My old structure scanner scans much better.

Did everything as instructed, it shows on Iphone it is LINKED to the scanner, but when I run the app, and go into settings, there is no option for Connect to device. And the tiny WiFi signal strength meter on it has an X. It does not detect the scanner.

3D Scanning on the go with my own portable battery pack