SolarLife BT

4 years and LOAD still doesn’t work.

The app doesn’t stay connected to the charge controller. It’s exactly what I need when it works, but it’s frustrating to have to manually reconnect it 7-8 times in a row.

Had trouble starting the car the other week because the accessory cut off was set to the recommended 11.2v which was too low for my rav4 4 cylinder.

I can successfully connect via Bluetooth (even though you have NO IDEA what the Bluetooth name is). After 30 minutes of waiting the app still won’t show any data for the battery or MPPT controller. I have tried many times. I can’t seem to be able to contact the developer either.

Read the order reviews. Same thing for me. Please fix these two issues and it’ll be a great app.

Generally works and reports what it gets from the controller. I wish it would remember what I connected to last and automatically reconnect and show the status page instead of the connect page. There are a couple of things but it might be the fault of the controller. The app reports an inaccurate battery percentage and charge status. Says 99% but battery is at 13.4V. Also reports always in chargefloat mode even if I change the thresholds. I see current going into the battery so I’m probably good for my application (automotive AGM top off charger).

As the other reviewers stated the Bluetooth doesn’t stay connected (small inconvenience). The larger issue is it isn’t monitoring the load on the battery bank. If this was fixed in a update I would give it four stars.

The LOAD screen parameters remain at zero even when a 6A load (light bar) is on and running….the app has run flawlessly on PV and BATT…easy setup etc…except for load side

Decent app. 3 stars because it constantly disconnects. I can reconnect it easily but it’s still annoying. If the app would at least attempt to reconnect automatically, I’d give it 5 stars. A few seconds of not showing values while reconnecting is better than having it fully disconnect and require me to reconnect manually.