BattAir

Make it possible to set the storage mode more flexibly, such as 3.85 volts and higher! 可以更灵活地设置存储模式，例如3.85伏及更高！

Really a pain to use. Unintuitive and buggy. Devices don’t connect half the time. Not possible to modify capacity of pack if you made a typo during setup.

I like the ability to check battery level in my RC boat without opening the hatch. After a few minutes of fun I come back to loiter by the docks and without taking the boat out of the water or opening the hatch I can see how much juice is in each of the batteries. Also helpful to spread usage evenly across multiple batteries y by tracking charge cycles.

Just using as a basic cell monitor. Does what I need

I found a bug in the BattAir devices and wanted to report it. I configured the auto discharge timer for 12 hours. After 12 hours the auto discharged started. I then decided to charge the packs before the auto discharge was complete. I held down the button several seconds to cancel the auto discharge and proceeded to charge them. The LED goes out so I assumed it was canceled. However minutes later the auto discharge started again. So it would not cancel. The only work around I’ve found is to unplug and plug in the BattAir to reset the 12 hour timer. Can this be fixed in a firmware update?

I purchased the battair plugins BAP4 and theyre completely useless because every time I try to open this app it crashes immediately and closes.