Revo Scan-3D scanner app

Developers, Russian will be?

Amazing! It is easy to use and have a magic function “ undo”. It provide very good quality of scans, I like to use it more than PC version!

Уважаемый разработчик а где выбор подключения к iPad (usb или Wi-Fi mode)

I purchased the range, I am frustrated with the product movement sensor accuracy, so far none of my model (I even tried a simple mug)can be scanned fully, you could only take freeze scan, once you start moving the sensor slowly, the scanning returns on the screen with a sudden drop or fast movement like jump into a limbo and kept rotating itself, as a result, my model flies everywhere. I don’t know how this can be solved?

Run a few scans from mobile and so far it seems to work pretty well with Pop 2. Still a little rough here and there and a few glitches but mostly works ok

The app seems to run ok. However one in every five or six scan attempts will just crash the app. Getting back in is quick but it’s still very annoying. Hopefully stability improves, and I can update my rating

I noticed when you use the app with the scanner, and also use it to convert it to a Mesh, it is very low quality, as compared to the Desktop App , and also there is no way to change the Mesh settings to be able to create a higher quality file. I hope in next update , you add the function of being able to save the file in higher quality Mesh file.

Junk , does not work on iphone 15

The scanner works fine on a laptop, but I bought the portable scanner to use with my phone. I have to connect the scanner to the app via WiFi and it barely works, or more often simply doesn’t. The iPad Pro, iPad Air, and iPhone 15 add have USB C, it’s high time that these guys modify the app to use USB support so we don’t have to try to rely on the extremely spotty WiFi connection to the app.

This app is terrible. I have issues with connecting to the scanner, then performing the scans. I connect power to the unit and wait about 30 seconds. Then I connect to the scanner’s WIFI. Then I open the RevoPoint app. Fir a very, very long time, up to 7 minutes, the app says, “No scanner detected. Connect a scanner.” Finally if/ when it connects, I get to the section where you set the scan settings. Once i do that and then press the button to start the scan, I get 4 spinning red dots, and one of two things happens: 1. In up to 5 minutes, the 4 round dots go away, and I can scan. 2. The spinning red dots never go away. Then I force close the software and start all over again. Sometimes I’m not able to get it to scan no matter what I do. This does not happen on the computer app. I’m running IOS 16 on an iPhone 13. I do not remember this happened when I first got the device. 2 things changed since then, a scanner firmware update, and updating to IOS 16. Once I do get a scan going, the phone app does have significantly more trouble keeping tracking of the object than on the computer. I tested this by scanning the same object using both methods. Also, not related to this app, but it seems this device in general, works much better when the scanner is stationary, but the scanned object is placed on a rotating platform. Unfortunately this isn’t always feasible unless you are scanning a small object.