Sculpto

Every file I have will not load the app says “Processing failed” check you have a valid ATL file. I downloaded all files from Thingaverse which this App required. Reddit users have had the same issue with prints they have already used before.

100% of their problems could be fixed with an update and adding a few features that they refuse to do for some reason

The upload file, edit preview is broken after the update was installed. Opened a ticket with support.. no answer back.

Successfully logged into Thingiverse after a lot of failed attempts but the app itself WILL NOT WORK. I’ll click on an item and it just gives me the same blank screen every time. I haven’t even received the Sculpto printer yet and now I’m super worried it was a waste of money because of the app being such a pain already. Hoping it prints okay. Not feeling super hopeful.

Almost every time I try to print something I need to stop it or turn it off, and when you turn it off you need to reconnect it to the internet and 99% of the time it takes at least half an hour or more and half the time I give up

It’s not THAT bad. Just requires a lot of patience. Hardware seems very out of the box and go, but software isn’t quite that way yet. However after learning my way around the bugs and whatnot, it’s easy to use.

Using the app is horrible. Took forever to get the app connected to the printer, and when I couldn’t get the filament to feed into the printer, the FAQ says to reset by turning the printer off. But then, I was locked out of the app. Now, I can’t even log back into the app, or create a new account. I’m over this app and the printer. I wish I had read the reviews here first.

The only challenging part of this plug and play printer is the WiFi setup. It must be over a 2.4gHz connection and more importantly and NOT documented is it doesn’t use the highest security connection. Uses WPA or lower/none iirc? I found this detail on a YouTube comment on one of their non setup vids! If you don’t have access to edit your internet connection if needed this is a cheap accent piece. In regards to printing I would upload atlas files directly to the printer. It can use thingiverse to get models but sadly that giant database is poorly optimized that its a running joke. Sadly Sculpto doesn’t display all the info on said thingiverse pages such as remixes. Use a thingiverse viewer like 3dgeeks to get files to print or avoid thingi altogether. You can print from the app or from your printers WiFi page. Get the link from sculpto faq page footer. To print gcode files you must use that printer website. Using gcode also..voids your warranty. Remember this is geared to novices who might not know how to slice. Happy printing and check out the 3D printing reddit or discord for help and tips

I created a username at Thingiverse, but it doesn’t work. I can’t login to the site at all.

Terrrible