SmarTemp 3.0

Why can’t more than one timer be enable? Why can’t timers be set to repeat daily? The connivence of BT is great but please remove these basic limitations. The app and heater has so much more potential!

The timer situation is just annoying. I’d rather go back to my multicontrol. There is only four timers. And you can only set one at a time. Makes no sense. And no option for everyday of the week. Like make the heater turn on everyday at 6pm? Instead you have to manually change the day to next day everyday. Because there are only 4 slots. Trash

I like the fact that all of us can look at diagnostics now. Definitely easier to figure out what’s going on.. I have an Airtop 2000 gas unit. Currently learning about and dealing with carbon.. sadly, only after a few days of running it overnight at low altitude. my current complaint is regarding the thermostat that I can’t really use in the traditional sense. It works really well but before I knew it, I had carbon blowing out the exhaust from short cycling and running on medium low. I thought I would switch to using timers but according to the manual, I should be able to pick “all” for days of the week and currently that isn’t even there. can we add the “all” like the manual shows? That and make it like the old 2.0 where it shows the week like a calendar with 4 timers per day? My other request is that the app also give you the ability to run the heater between a temperature range. If I want it to turn on at 60° and off at 75 deg, for example, that would allow the heater to run on High longer, and save me the time of doing all this stuff manually to save my heater..