Spark for Nanoleaf

The setup should be simple if it works great otherwise good luck

There isn’t any support for this app. No YouTube videos, no email, no numbers to call. I do like it. It’s better than factory.

I don’t mind paying to remove ads, but if the application is free with ads, it should at least be usable enough for me to determine whether I want to pay. The ads in this app are so frequent, so large, and so time consuming, that attempting to figure out how to use the thing was an exercise in frustration. I deleted it within ten minutes.

The first thing the app asks for is which device to pair. I have three sets on three controllers. This app shows the three, but instead of the names I assigned them (Bedroom, Kitchen etc), it shows as “Shapes 43F”, “Shapes B99B”, and “Shapes A560”. How am I supposed to know which is which? Dead on arrival.

This has brought a whole new dimension to my Nanoleaf Shapes. (Note: I have added magnets to my panels on a magnetic white board to allow easy moving of panels.) This app has allowed the further expansion of individual animation to each panel to allow almost unlimited creativity. A new art work can simply be made with almost maximum control of each panel. Looking forward to further updates! PS Also using Kami2 app to plan has helped a lot.

This app is crazy how seamlessly it works with the shapes for being a 3rd party! The options are amazing, better than the actual app. I would say the only issue I have is that the scenes I make don’t work with Siri or the HomeKit, and can only be accessed within this app. Other than that it’s amazing