The app is only good for file hosting and printing via WiFi. Slicer so far has not produced a useable output for me. Slicing the same file with same setting on this app vs Cura, the Cura gcode produced the expected result and this app produced trash (I liretally just dumped it as it is unusable). Hopefully it can support non Creality webcams. The app prompted that the webcam should be H.264, 30fps, 1080p but even if I have a webcam that fit the spec, it still didn’t work. My webcam is plug and play as well and doesn’t need driver so hopefully in the future it can get supported.