Onkyo Remote 3

Of all the apps, I hate, I hate this one the worst. It is the slowest to load it’s absolutely garbage. I can’t wait to replace this Onkyo receiver with something else

It just never works

That’s it. After upgrading, Remote3 stopped connecting with my TX-NR717. I suspect UDP blockage, but I won’t swear to it. App goes to Searching screen and I can’t get away from that screen to check settings. I am very disappointed after years of satisfaction with this app. I have little hope that it will be fixed after this long not working. Bummer.

It will work perfectly, allowing me to control my zone 2 outdoor music, for a few weeks. Then suddenly it stops connecting to the receiver. I’ll go through every possible solution and nothing works. Then all of the sudden. It starts connecting again. Frustrating to say the least.

I’ve had my onkyo for about 7 years. The remote worked for a few years but now it’s hit or miss. Mostly miss. Very disappointing that the remote rarely connects to the unit so it’s unusable.

I have to say this app has worked absolutely beautiful for me. Easy to use and intuitive. A lot easier to use than the A/V original remote. And I’ve never had a problem with the app finding and/or connecting to the A/V Receiver or WiFi network. I gave the app 4 stars (instead of 5) because there is no option to listen to the audio via Bluetooth headphones, an option that available in other similar apps.

When we first started using this it worked great. That’s not the case anymore. Every time I try to connect my iPhone music to the app just like always before it doesn’t find it. It just keeps searching. Please fix this!!

I have been using your app for speakers in our bathroom room for years and occasionally there’s a hiccup when updates happen. Can you please update that connection, however you do it, on your end please?

The app has worked well for years and now it cannot find the receiver on the network. I even tried using the new app and when given the network address it says the device is not controllable. Please fix your broken update.

My new TX-NR6100 receiver is hard wired on my network, firmware update went fine. Loaded this app to try remote control and it does not see the receiver. I am using the latest Google wireless router plugged into the ATT fiber router. My previous Yamaha receiver worked fine with the same network connection and my iPhone app. Onkyo please modernize this app to work properly or take it off the store.