IntelliCenter2

Good technical support when needed assistance.

When you re open the app after some time it shows outdated data until you kill the app and relaunch it.

Like the app. Good general functionality. Biggest complaint is that it doesn’t seem to refresh. Need to shut down each time and then restart to establish the connection and check updated readings. Ie. Spa temp. Would be great if this could be fixed.

Under the chemistry tab when you select chemistry menu the app crashes

Thank you for the reply. Yes the freeze protection is checked off in settings but I meant that on the first opening page of the app where the current status of all is shown it used to show that Freeze Protection had for sure come on. Looked just like the actual panel. I liked it because then I knew something had not been set wrong (or unchecked in settings)particularly as two groups of pool contractors and maintenance crews go in to our pool equipment room. And yes Ive had to correct stuff in the past. Just saying it was reassuring to have proof it recognized the freeze protection and temperature sensor still working!! Cheers Better but disappointed that the Freeze Protection on notice has been eliminated from the app - its shows on the panel but not in the app when i check it from bed to be sure its on thank you…

The app doesn’t work with Apple Watch anymore. If you switch to another app, you will have to quit the app and login again before you can use the app.

Seems to connect slightly more consistent than previous version but no auto login so still takes a while. Watch app doesn’t work.

This app was working great for about 4 weeks, now it is disconnected from our pool. I have sent 2 emails to customer service & have not had an answer so maybe they will respond to the review. It is frustrating that other reviewers have mentioned the exact same problem & Pentair has no solutions for this known issue publicly available. I am logged in but disconnected from the pool. It will not connect & is asking for an IP address & Pin. My pool builder doesn’t even have an answer to this. Please help Pentair!!! Please do not tell me to email your customer support, I’ve done it twice…check the emails & respond to that.

I’ve had this new app a few months. No matter what I try, I can never log on and the system never recognizes my username or passcode. So frustrating to use and can’t do anything without going over to the actual control panel. I have check and tried and rebooted several times.

Trying to control the SPA temperature with Apple Watch Ultra 1 , cannot increase temperature , just decrease, I was using screen logic before , it seems this app is not mature yet , not recommend to upgrade from screen logic controller