Focal & Naim

V podstatě vše funguje. Po poslední aktualizaci bylo potřeba provést tovární reset MuSo2 a aplikace a vše nastavit což je časově zbytečné!

Even though naim products are not cheap, this app looks like associated to some 20$ product from aliexpress. Not a single improvement in years and I cannot even easily change vol on one click after last update.

Often drop outs and a new set up nearly impossible. It loos like it is a matter of an accident.

12.3.- Naim muso qb gen 2 plně funkční - Naim muso gen1 se v pouhých 5% rozezná a připojí k aplikaci. Velice špatná aplikace. Obě zařízení jsou ve stejné síti a jsou připojena Lan kabelem. Přesto gen2 je mnohem lépe optimalizovaná než gen1. 18.2. Aplikace nedokáže najít muso ve stejné síti. 1x z 10 pokusů je úspěšná. Edit: Computer network is ok Naim device is connected via lan.

Seems my experience with the Naim app is different (better) than of some other reviewers. I am using it to control UnitiQute 2 and Mu-so. While the UI is say not up to latest and greatest standards, it gets the job done. I am not experiencing stability issues (iPhone nor iPad) and I can control all key settings and features of my Naim hw. Integration with upnp works very well too. I am giving it 4* as the integration with Spotify (again, from the UI interface) is more complex than it needs to be (too many clicks to get where one needs to be). Once there, controls work well. Naim does exceptionally good hardware, including the software layer that is built into their network connected devices. One of the most responsive I have experienced (comparing to other network streamers from Marantz, Pioneer, Onkyo, etc.) I think once you improve the mobile apps experience, and the UX/UI particularly, you will have full “chain” well balanced.

Tato aplikace když funguje,tak vcelku OK.Ale bohužel často padá.Hlavně na Ipadu Pro ale i na androidu.Nevím jak to testují.Opravdu jen průměr.Měli by si vzít příklad z aplikace od Yamahy.To je král všech audio aplikací.Děkuji.

On the positive side, I have never had any connectivity issues - but all I have is a single Atom HE connected via ethernet and accessed by an iPad and iPhone via a BT vanilla WiFi network…. Overall the UI is OK but what frustrates me about the app is the way it still looses state when you switch from one option to another and back again - eg say I was listening to Qobuz and a news flash comes up, I switch to to Internet Radio to hear whats happened and then switch back- what I was listening to on Qobuz has gone as has anything else I had queued up.. I fail to understand why this obvious use case hasn’t been sorted.

I purchased a pair of Focal Bathy headphones from Richer Sounds and now having been using them regularly for over a month, I’ve noticed an issue with them. Basically it’s with the volume adjustment and finding the headphones either too quiet or too loud. I just want to be able to turn them up by a small amount, but the jump up in volume at this point is too large and overpowering. It goes from not quite loud enough" to "too loud" quickly, (in one volume step) there’s simply not enough adjustment range . At the moment, I just cannot enjoy listening to them. A firmware update could solve this problem as I’m not the only one with this issue. Having seen it described online by quite a few other uses on different headphone forums so it’s not only me. It turns out these headphones only have 16 increments of volume whilst most other headphones including my Sony’s have 32 increments of volume allowing for fine adjustment.

Blimey. What have Naim done? App improved and now works seamlessly. Nice.

Used to word fine, now have constant connection issues.